We cover New Market and the rest of Madison County, from Winchester Road across to Ford Chapel, and we are out this way often enough that Madison and Meridianville are on the same run.
Between the established parts of New Market and the newer subdivisions, we see two different kinds of failure: worn-out frames on one side of town and worn-out hardware on the other.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Signs you need door closer repair in New Market
These are the door closer repair faults we are called out to most often in New Market. If you recognise one, the underlying cause is usually the second half of the line.
- The door does not close the last inchClosing force is too low, or the door is binding on the frame in the final approach.
- Grinding from a floor closerWorn spindle or bearings in the floor unit.
- Screws pulling out of the door or frameCloser mounting has failed, often because the closer was undersized for the door.
- The closer works well cold and slams when hotFluid thinning with temperature in a unit whose valves can no longer compensate.
- Mounting screws have pulled the door skin outwardA closer fitted to a hollow door without a reinforcing plate.
- The door slams open against the wallBackcheck has failed or is not adjusted, and the arm and frame are taking the impact.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895What we see on door closer repair around Madison County
The Tennessee Valley runs a wider temperature swing than most of Alabama. Summer humidity sits on aluminum and vinyl frames for months, then December through February drops below freezing dozens of nights, and the valley picks up an ice event every few winters.
Water running down a door face and into a surface closer body corrodes the internals and the mounting fasteners, and a closer that has been wet repeatedly usually fails at the seal.
Humidity swells a wood door so it drags in the frame during the final approach, and turning the closer up to overcome that makes the door punishingly heavy to open while doing nothing about the actual cause.
None of it is a reason to replace a door. It is a reason to use the right parts and set the door up correctly in the first place.
Local factors we account for in New Market: heavy rainfall and sustained humidity — typical of the Tennessee Valley.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895Door closer repair work we handle in New Market
- Concealed closer serviceOverhead concealed closers in aluminum storefront doors repaired or replaced.
- Floor closer repairServicing and replacing floor-mounted closers under heavy entrance doors.
- Wind and stop protectionFitting overhead stops so wind cannot destroy the closer arm.
- Fire door closer complianceMaking sure fire-rated openings close and latch fully every time.
- Accessibility force adjustmentSetting opening force to meet accessibility requirements without losing reliable latching.
- Hold-open arm serviceRepairing and adjusting hold-open functions.
- Mounting repairRepairing or reinforcing door and frame where closer fasteners have pulled out.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895How we approach door closer repair
- Time the closeA door that shuts in under five seconds or fails to latch tells us which valve is at fault before the cover comes off.
- Rule out the door firstA closer struggling against a binding door is not a faulty closer. Hinges and reveal get checked before we condemn the unit.
- Adjust before replacingMost closer complaints are solved with valve adjustment, and we do that first.
- Size the replacement properlyDoor width, weight and exposure decide the power size. An undersized closer will not shut the door; an oversized one shuts out anyone who is not strong.
- Set for people, not just for latchingThe door needs to close and latch every time and still be openable by someone with limited strength.
- Fit a stop where it is neededA door with no stop will destroy its own closer the first time the wind catches it. We look at how the opening behaves wet and dry, since the fault often only appears in one half of the year.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895What affects the cost of door closer repair in New Market
We would rather tell you what drives the price than quote a number that turns out to be wrong once we see the door. On a door closer repair job in New Market, the main variables are these:
- the size and weight of the door and its exposure to wind
- adjustment versus rebuild versus full replacement
- fire rating and accessibility compliance requirements
- surface, concealed or floor mounted closer type
- whether the mounting has to be repaired or reinforced
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to New Market.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Areas we cover for door closer repair in New Market
New Market coverage runs across Winchester Road and Ford Chapel, and out to the areas around the Flint River and Sharp Mountain.
We also cover the nearby Madison County and the Tennessee Valley communities listed further down this page.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Door closer repair in New Market: questions we get asked
My door does not close all the way. What is going on?
Either the closing force is too low, or the door is dragging on the frame in the last few inches. In New Market we see the second one often, because a frame that has moved makes a good closer look weak.
Do you work on floor closers?
Yes. Floor closers under heavy entrance doors are serviceable, though they are more involved to work on because the unit sits in the floor.
My door slams every time. Can that be adjusted?
Almost always. There is a latch speed valve on the closer that controls the last few inches, and it has probably drifted or been set wrong. Adjusting it takes minutes and saves your frame, hinges and hardware from a lot of abuse.
Why is our door so heavy to open now?
Somebody has probably turned the closer up to force a door that was not latching. That is treating a symptom, and it makes the door difficult for customers and staff. Fix the latching problem and the closer can come back to a reasonable setting.
There is oil dripping from my door closer. Can it be refilled?
No. Closers are sealed units, and once the seal fails the closer is finished. Refilling is not possible on standard units and the unit needs replacing.
Can I adjust the closer myself?
The valves are accessible, but they are easy to over-adjust and some closers will lose their spring tension entirely if a valve is backed out too far. If you are not sure which valve does what, it is worth a call first.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Other door repair services in New Market
- Sliding Door Repair New Market
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair New Market
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair New Market
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair New Market
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair New Market
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair New Market
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair New Market
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair New Market
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair New Market
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Automatic Door Repair New Market
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair New Market
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair New Market
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair New Market
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair New Market
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair New Market
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Closer Repair near New Market
We cover the surrounding Madison County and the Tennessee Valley communities as well:
- Door Closer Repair in Madison
- Door Closer Repair in Meridianville
- Door Closer Repair in Harvest
- Door Closer Repair in Hazel Green
- Door Closer Repair in Moores Mill
- Door Closer Repair in Triana
- Door Closer Repair in New Hope
- Door Closer Repair in Owens Cross Roads
All door repair services in New Market · Door Closer Repair across Alabama · All Alabama service areas
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895