Our Frisco City customers are spread from Main Street to the AL-21 corridor and out around the Frisco City depot, and we serve the surrounding Monroe County communities on the same schedule.
The mix of housing here matters for door work. Older Frisco City homes have wood frames and hardware worth repairing rather than replacing, while newer construction tends to have vinyl and aluminum systems where the moving parts wear out long before anything else does.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895When to call about commercial door repair
These are the commercial door repair faults we are called out to most often in Frisco City. If you recognise one, the underlying cause is usually the second half of the line.
- The closer is dropping oil down the doorFailed seal in the closer body; the unit is done.
- The door swings past the frame and hits the wallNo stop fitted, or a failed backcheck in the closer, and it will damage both eventually.
- The door has dropped out of square in the frameHinge failure or building movement, and it stops the door sealing and latching.
- The astragal on a pair has bent outwardRepeated forcing of the inactive leaf, usually because the flush bolts are seized.
- The door will not latch and has to be pulled shutCloser adjustment, hinge wear or frame movement, and it is a security failure until fixed.
- Rust at the bottom of a steel doorWater sitting at the threshold; the door bottom is rotting out.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895What we see on commercial door repair around Monroe County
Salt air is the single biggest factor on the coast. It attacks the steel inside roller bearings, hinge pins, latch mechanisms and closer springs, and it does it year round whether or not a storm ever comes.
Humidity swells wood commercial doors and rusts the internals of hardware on doors that are propped open for ventilation, which is very common in kitchens and back-of-house areas.
Grit tracked through a commercial entrance ends up in the closer arm pivots, the latch and the threshold, and on a high-traffic door that abrasive load shortens hardware life dramatically.
We see the pattern often enough across Monroe County that we usually know what we are looking at before we arrive.
Local factors we account for in Frisco City: sustained humidity and blowing sand — typical of the Alabama Gulf Coast.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Commercial door repair work we handle in Frisco City
- Exit device and panic bar serviceRepairing and replacing panic hardware so it latches and releases correctly.
- Continuous hinge installationFull-length geared hinges on doors that keep tearing out standard hinges.
- Door bottom and edge repairRebuilding corroded steel door bottoms rather than replacing the whole leaf.
- Preventive maintenance programsScheduled service so doors get adjusted before they fail.
- Hollow metal door and frame repairRepairing impact damage, corrosion and worn hardware locations in steel doors and frames.
- Door closer repair and replacementSurface, concealed and floor closers adjusted or replaced.
- Weatherstrip, sweeps and thresholdsSealing service doors against water, air and pests.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Our commercial door repair process
- Get the opening secure firstIf the door cannot be secured, that gets solved before anything else, even if the full repair needs parts.
- Assess door, frame and hardware togetherOn commercial openings the fault is rarely in one component. Closer, hinges, frame and floor all interact.
- Work around your hoursWhere the job allows it we schedule outside trading, because an entrance out of service during business hours costs more than the repair.
- Specify to the environmentKitchen, loading bay and customer entrance are three different specifications, and we fit to the one in front of us.
- Set for code and accessibilityOpening force, closing speed and latch timing are checked against requirements, not just set to feel about right. On the coast we also check every fastener on the opening, because salt finds plated screws long before it touches the door itself.
- Document what was doneProperty managers need a record of what was repaired and what is coming due.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895What affects the cost of commercial door repair in Frisco City
Every commercial door repair call in Monroe County is a little different, and the cost follows what the door actually needs:
- the number of openings serviced in one visit
- the type of door: hollow metal, aluminum storefront or wood
- access control components on the opening
- after-hours or emergency response
- whether the frame needs repair as well as the door
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Frisco City.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Areas we cover for commercial door repair in Frisco City
We work throughout Frisco City, including Main Street and the AL-21 corridor. If you are near the Frisco City depot and Monroeville just north, that is inside our normal service area.
We also cover the nearby Monroe County and the Alabama Gulf Coast communities listed further down this page.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Commercial door repair in Frisco City: questions we get asked
Our back door will not latch unless someone pulls it. Is that serious?
It is a security failure and often an insurance issue. A door resting closed but not latched is not locked. It is usually a closer or hinge adjustment, and it should be dealt with quickly.
Do you service fire-rated doors?
Yes. Fire doors have specific requirements for gaps, closing, latching and hardware, and they are the doors most likely to fail inspection because someone propped them or replaced hardware with the wrong parts.
What causes rust at the bottom of our steel doors?
Water standing at the threshold. In Monroe County that is usually drainage at the entrance or a failed sweep, and the door bottom can often be rebuilt rather than replacing the whole leaf.
Do you handle doors with electric strikes and access control?
Yes. We also find that a lot of access control complaints are actually mechanical: a door binding or a strike out of alignment makes perfectly good electronics look faulty.
Can you work outside our business hours?
Yes, and for a lot of Frisco City storefronts and restaurants that is the only sensible way to do it. Tell us your trading hours when you call and we will schedule around them.
Why does our hardware keep failing when the house across the street has hardware that lasts forever?
Cycle count. A busy Frisco City storefront door might see more use in a month than a residential front door sees in a year. Grade 1 commercial hardware exists for exactly this reason.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895Other door repair services in Frisco City
- Sliding Door Repair Frisco City
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Frisco City
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Frisco City
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Frisco City
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Frisco City
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Frisco City
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Frisco City
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Storefront Door Repair Frisco City
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Door Closer Repair Frisco City
Closers adjusted, rebuilt and replaced so doors shut properly instead of slamming or hanging open.
- Automatic Door Repair Frisco City
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Frisco City
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Frisco City
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Frisco City
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Frisco City
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Frisco City
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Commercial Door Repair near Frisco City
We cover the surrounding Monroe County and the Alabama Gulf Coast communities as well:
- Commercial Door Repair in Monroeville
- Commercial Door Repair in Daphne
- Commercial Door Repair in Fairhope
- Commercial Door Repair in Foley
- Commercial Door Repair in Gulf Shores
- Commercial Door Repair in Orange Beach
- Commercial Door Repair in Spanish Fort
- Commercial Door Repair in Bay Minette
All door repair services in Frisco City · Commercial Door Repair across Alabama · All Alabama service areas
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895